#PCB DESIGN RULES SPACINGS PATCH#

When all components of the circuit are laid out, the following principles should be followed:ДЎ. In the layout design of PCB, the elements of the circuit board should be analyzed, and the layout design should be carried out according to the functions. It is advisable to add grounding wires between these conductors. The printed conductors used for the input and output of the circuit should avoid adjacent parallel lines as far as possible, so as to avoid the occurrence of feedback. When two panels are wired, the wires on both sides should be perpendicular, oblique or curved to each other to avoid being parallel to each other, so as to reduce parasitic coupling. The bending of the printed conductor should be rounded, and the right Angle or sharp Angle will affect the electrical performance under high frequency circuit and high density of wiring. The arrangement of printed wires should be as short as possible, especially in high frequency circuits. For example, if you want to bear the pressure test of 3000 v, the distance between the high and low voltage lines should be above 3.5 mm, in many cases to avoid creepage, also on the PCB board slot between high and low pressure.Д¦. On many PCB which have high voltage and low voltage circuit, at the same time of the components of high voltage circuit with low voltage part to open space, distance between related to bear pressure, is often the case in the 2000 kv distance on the PCB to 2 mm, on top of this ratio is also increased. When the circuit board is larger than 200MM x 150MM, the mechanical strength of the circuit board should be considered.ДҐ. The minimum spacing between the shapes of different components on the circuit board should be more than 1MM.Д¤. The elements should be compact in arrangement, and they should be uniformly distributed and spaced on the whole layout.ДЈ. In order to make sure the electrical property, the element shall be located on the gridlines and in alignment, to keep it natty and artistic.

#PCB DESIGN RULES SPACINGS PATCH#

Only when the top layer is too dense can some devices with limited height and low heat generation, such as patch resistance, patch capacitance and patch IC, be placed at the bottom layer.Дў. Normally, all components should be placed on the same side of the boards. That is to say, have a certain circuit basis, to your PCB will be able to see which block is used to realize what function.ДЎ. That the placement of what is reasonable, the principle of a simple is the clear modular division. Layout means that the circuit elements are properly placed.

Pcb design rules spacings